Fuel - Horizontal Stabilizer Fuel Tank - Inspection
- Published
- Takes effect
AI-generated summary of the official EASA document. Verify against the PDF before acting.
What to do
Operators of affected Boeing 747-400 and 747-8 airplanes must perform repetitive detailed inspections of the transfer pump housing inlet check valves and transfer pump motor impeller inlet adapters starting by December 7, 2026. If damage is found, they must replace the affected parts following the options specified in the Boeing Alert Requirements Bulletin 747-28A2373 RB. Installation of affected parts is limited under certain conditions, and operators should maintain compliance with all inspection and replacement requirements to meet the AD.
Summary
Fuel - Horizontal Stabilizer Fuel Tank - Inspection is a Federal Aviation Administration (FAA) Airworthiness Directive (AD 2026-22-04) that applies to certain Boeing Model 747-400 and 747-8 series airplanes. This directive mandates repetitive inspections of the transfer pump housing inlet check valves and transfer pump motor impeller inlet adapters in the horizontal stabilizer fuel tank to detect damage and requires corrective actions if necessary. It also restricts the installation of affected parts to prevent ignition sources within the fuel tank.
What changed
This AD supersedes AD 2023-07-09 by introducing repetitive inspections for damage to specific components in the horizontal stabilizer fuel tank and specifying on-condition corrective actions. It clarifies applicability by referencing Boeing Alert Requirements Bulletin 747-28A2373 RB for affected airplanes and limits installation of certain parts under defined conditions. The directive is considered an interim action pending further analysis of similar components in other fuel tanks.
Why it matters
This AD addresses a critical safety risk where wear in transfer pump components could create an ignition source inside the horizontal stabilizer fuel tank, potentially leading to a fuel tank explosion and loss of the airplane. Compliance ensures continued airworthiness and safety for operators of affected Boeing 747-400 and 747-8 aircraft. Maintenance and compliance teams must monitor and replace damaged parts to mitigate this unsafe condition and avoid operational disruptions.
More for Boeing 747
All 81- EASA AD US-2026-13-03Fuselage - Stringers and Stringer Splice Fittings - InspectionJul 7, 2026
- EASA AD ISR-I-35-26-01-01Potential of arcing, fire and/or loss of crew oxygen supply due to insufficient clearances between electrical wiring and flexible oxygen hoseJan 1, 2026
- EASA AD US-2025-15-07Equipment / Furnishings - Captain's and First Officer's Seats - Inspection / CheckJul 31, 2025
- EASA AD US-2025-09-08Stabilizers - Outboard Elevators - Maintenance Records Check / InspectionMay 5, 2025
Get the next one by email
New ADs and bulletins for Boeing 747, summarized like this page, every Monday.