Turbine Engine Compressor Section - Variable Geometry System Actuator - Replacement
- Published
- Takes effect
- Deadline
AI-generated summary of the official EASA document. Verify against the PDF before acting.
What to do
Affected operators must remove the specified EEC FADEC software versions and install the updated software eligible for installation. Compliance with this directive is mandatory by November 27, 2026. Maintenance and compliance teams should review affected engine serial numbers and schedule software updates during regular maintenance to avoid operational disruptions.
Summary
The Federal Aviation Administration's Airworthiness Directive 2026-21-11 addresses certain General Electric Company CF34-8 series engines, including models CF34-8C1 through CF34-8E6A1. This directive responds to in-flight "Engine Degraded" messages caused by corrosion in the variable geometry system actuator. It mandates software updates to the electronic engine control full authority digital electronic control (EEC FADEC) system to mitigate this unsafe condition.
What changed
This new airworthiness directive introduces a requirement to remove specific versions of EEC FADEC software from service and replace them with updated, eligible versions. It targets corrosion-related issues in the variable geometry system actuator that can cause engine performance degradation and throttle lock conditions. The directive applies to multiple CF34-8 engine variants and establishes compliance protocols to address these safety concerns.
Why it matters
This directive is critical for aviation professionals because it prevents potential in-flight engine performance issues that could compromise safety. Operators and maintenance organizations must ensure affected engines are updated to avoid unexpected engine idle conditions and throttle lockouts. Compliance reduces the risk of corrosion-induced actuator failures, maintaining engine reliability and operational safety.
More for General Electric CF34-8
All 11- EASA AD US-2025-12-08Turbine Engine - Combustion Chamber Assembly - InspectionJul 16, 2025
- EASA AD US-2023-02-05Time Limits / Maintenance Checks — Airworthiness Limitations Section — AmendmentMar 7, 2023
- EASA AD US-2022-21-06Engine - Low Pressure Turbine Stage 5 Discs - Removal / ReplacementNov 10, 2022
- EASA AD US-2022-09-14Air - Operability Bleed Valve - Inspection / ReplacementMay 23, 2022
- EASA AD US-2022-08-06
Get the next one by email
New ADs and bulletins for these 13 aircraft types, summarized like this page, every Monday.